14
The accuracy of the radiator’s temperature reading can be affected if the unit is
mounted such that the sensor is positioned in a hot or cold spot – such as hot water
pipes or a draughty doorway. The sensor is at the bottom right of the unit.
• Press to put the radiator into standby mode and hold down for 5
seconds to enter the settings menu.
• F0 will appear on the screen, followed by the current set temperature
compensation. Default is 0 °C.
• Use the and keys to adjust. Temperature compensation can be
adjusted from -5 to 5 °C in steps of 1 °C.
• Press to confirm and move onto the next setting.
4 – 4 – 2 | Sensor Mode (F1)
This setting controls how long the radiator will wait, when a presence is no longer
detected in sensor mode, before dropping to a more energy-efficient mode.
• Press to put the radiator into standby mode and hold down for 5
seconds to enter the settings menu.
• Press to skip through the settings until F1 appears on the screen, followed
by the current sensor time interval. The default is 15 minutes.
• Use the and keys to choose 15, 30, 45 or 60 minutes.
• Press to confirm and move onto the next setting.
4 – 4 – 3 | Open Window Detection (F2)
Open window detection is an energy-saving feature designed to cut power to the
unit if a window is opened. If the radiator detects a sudden drop in temperature (2
°C or more within 5 minutes), the icon will appear and the radiator will switch to
anti-freeze temperature to prevent energy wastage as heat escapes through
the window. The F2 setting controls how long the radiator waits before switching
back to the full set temperature. Open window detection is disabled by default.
• Press to put the radiator into standby mode and hold down for 5
seconds to enter the settings menu.
• Press to skip through the settings until F2 appears on the screen,
followed by the current setting. Default is “0” – disabled.
• Use the and keys to adjust. Choose 60 or 90 to enable the feature
and set the number of minutes, or choose “0” to disable detection.
• Press to confirm and move onto the next setting.
To Next Page
Loading...
