13
based on whether the room is occupied. The icon flashes whenever the sensor
detects a presence.
When a presence is detected, the radiator heats at comfort temperature . When
a presence is no longer detected, the radiator will wait for a set interval of time
before stepping down the temperature. This interval is 15, 30, 45 or 60 minutes and
can be adjusted in the settings menu – see
4-4-2.
Once the set interval with no presence detected has elapsed, e.g. 45 minutes, set
temperature will be reduced by 1 °C. If a further 45 minutes passes with no
presence detected, the set temperature reduces by a further degree. After another
45 minutes with no presence detected the radiator switches to the eco set
temperature . The radiator holds this temperature for 24 hours. If no presence is
detected in this time, the radiator switches to anti-freeze mode .
If at any point in this cycle a presence is detected, the radiator will switch back to its
previous state. If a presence is detected in the next 15 minutes, the radiator will
switch to the next state up. This continues until the radiator resumes full comfort
temperature . This 15 minute interval cannot be adjusted; the adjustable setting
affects only the interval the radiator waits when a presence is not detected.
4 – 3 – 6 | Pilot Mode
When the icon displays on the screen, the radiator is in pilot mode. This mode
activates external control of the device via a pilot wire (not supplied). Pilot mode
enables six externally controlled modes: Comfort, Comfort-1, Comfort-2, Economic,
Anti-Frost and Power Off.
This option is tailored to the French market and is not available on the UK model.
4 – 4 | Settings
The settings menu allows you to enable, disable and configure all the radiator’s
supplementary functions. Temperature compensation (F0), sensor mode (F1), open
window detection (F2), WiFi function (F4) and time synchronisation (F5).
Press to put the radiator into standby mode and hold down for 5 seconds to
enter the settings menu. You can also switch back and forth between modes by
swiping the touchscreen.
4 – 4 – 1 | Temperature Compensation (F0)
The temperature compensation setting allows users to adjust for any discrepancy
between the average room temperature and the temperature sensed by the
thermostat. For instance, if the temperature in the room is 18 °C, but the radiator is
sensing 16 °C, a compensation factor of +2 °C will offset the difference.
To Next Page
Loading...
