5.2
Manage Sensors
1 Add a Sensor
To pair the optional sensors (refer to Section 14 Optional
Sensors for more optional sensors) with the GW2000, please do
as follows:
1. Place the optional sensor next to the receiver.
2. Power the sensor on and wait for 1-2 minutes.
3. Check whether the GW2000 will pick up the sensor data
automatically and display it on the app.
4. If data is not received, try the following: Make sure the phone
and GW2000 are connected to the same Wi-Fi network, open the
Ecowitt App, find Sensor ID, and enter the Edit Gateway page.
5. In the Edit Gateway page, find the sensor you want to pair -
select the ID number box and register it.
6. Once successful, you may return to the main interface to
check the data.
7. If you know exactly the sensor ID, and want the GW2000 to
pair that sensor only, you may enter the sensor ID, and save the
change to make it effective.
To Next Page
Loading...
