you prevent the gateway from automatically receiving data from
other already registered transmitters.
If you have 2 or more transmitters of the same model, and
GW2000 receives data from one of them, you want to receive
data from another.
1. Tap the icon of editing.
2. Manually input the sensor ID of the transmitter you wish to
receive on this interface
3. Set its status to Enabled.
4. Tap "Save" to receive data successfully.
5. When the GW2000 receives data from an unwanted
transmitter.
6. Tap the icon of editing.
7. Manually input the default sensor ID to lock onto this sensor.
8. Set its status to Disabled.
9. Tap "Save" to apply this lock immediately.
To Next Page
Loading...
