6 Setup Guide using Wi-Fi Gateway
If you wish to view the sensor data on your mobile device, you need to
pair this sensor device with the Wi-Fi gateway (sold separately), or
another compatible display console device(sold separately).
Before you can use the mobile application to connect to the Wi-Fi
gateway, it must be configured on your Wi-Fi network. Instructions may
be found in the gateway manual.
6.1 Replacing an existing sensor unit
If this sensor is a replacement for a previous unit, ensure the previous unit
is powered down. Also unplug the Wi-Fi gateway from the USB
connection, wait a few seconds, and re-connect the gateway to USB
power.
Now simply insert the battery to power up the sensor unit, and the Wi-Fi
gateway will quickly pick up the sensor information. It is best to always
do this in the vicinity of the Wi-Fi gateway to rule out distance or signal
interference effects, and to move the unit to the final location once correct
configuration is confirmed.
To Next Page
Loading...
