FDM function demonstration
--------------------------------------------------------------------------------------------------------------------------------------------
24
------------------------------------------------------------------------------------------------------------------------------------------
--------
B EcubMaker TOYDIY basic setup and installation
5.Special Settings - adjust Z-offset
● Z-offset introduce：
Z-offset：The parameters used to calibrate the gap between nozzle and platform
during FDM 3D printing.
The default Z-offset value of this machine is on the cover of the manual.
When the toolhead is reassembled, this value may change and may need to be
adjusted
Z-offset adjust principle：
When FDM prints the bottom layer, if the nozzle is too tight with the printing
platform, z-offset value will be increased（EX：adjust -0.80mm to -0.60mm），
Otherwise, if the nozzle is too far away from the printing platform, the z-offset
value will be reduced.The degree of adjustment depends on the degree of
tightness or looseness.
Back
Auto Set Zoffset
> Manual Input Zoffset
【Auto】
： In the menu,Utility ＞ Z offset ＞ Auto Set Z offset，Place a
piece of A4 paper between the platform and the nozzle，then adjust the
distance between the nozzle and the platform by rotating the knob，
Make sure the nozzle is exactly an A4 distance from the platform . then
Save Settings.
Back
> Z offset(mm): -0.20
Save Settings
Back
> Auto Set Zoffset
Manual Input Zoffset
Back
> Step1:Auto home
> Step2:Adjust Zoffset
> Step3:Save and Reset
Back
> Z-offset Amend:-0.20
*Tips : This step has a very detailed video tutorial, it is recommended
to read the manual and then learn through video tutorial to deepen
the impression .
● Z-offset adjustment method：
【Manual】：
Use the default Z-offset value of this machine,Enter this value
in the menu below，Adjust the value according to the print.
To Next Page
Loading...
