EcubMaker TOYDIY - Laser Safety and Risks

------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------
--------
06
A
Welcome to choose EcubMaker
Safety Instructions
Safety Equipment
● Always equip a properly maintained and inspected re extinguisher near the
machine, and learn how to use it. A wet towel can also be useful in extinguishing
small res.
● Make sure smoke alarms are installed and tested in the building required by
local legislation and manufacturer recommendations.
Keep Watching During Operation
● Never leave the TOYDIY unattended while operating – always stay within
sight. Look at it frequently.
● A small ame where the laser beam strikes the material is normal. This ame
should move with the laser and should not remain lit when the laser has moved
past. If there is a lasting ame on the material:
①
Power off the machine and unplug the power adapter.
②
If it is safe to do so, extinguish the re with a wet towel or a re
extinguisher.
③
If the re can not be extinguished or if it spreads outside the TOYDIY,
call your local emergency number (for example 911) and evacuate the
building.
④
Do not operate the TOYDIY further until you have contacted us for se
rvice information at support@zd3dp.com.
Laser Safety
● Your TOYDIY Laser Toolhead is a Class 3B laser product. The laser emits
enough beam to cause skin and eye injury. The TOYDIY provides a Laser
Safety Glasses to protect your eyes. Wear the Laser Safety Glasses before you
set up the Laser Engraver and throughout the Laser Engraving process.
● Keep a safe distance from the machine when it’s Laser Engraving.
CAUTION!
Use of controls or adjustments or performance of procedures other than those
specied herein may result in hazardous radiation exposure.
Do not modify or service.
Attempting to modify or service the TOYDIY may result in hazardous laser light
exposure.
To reduce the risk of injury:
● Do not attempt service. All service must be performed only by the TOYDIY
factory or by factory-authorized technicians.
● Do not attempt to alter or modify the TOYDIY.
● Do not try to open sealed portions of the TOYDIY, including any protective
coverings or housings.
Smoke and Fume Safety
● When you use your TOYDIY, the laser creates visible and invisible aerosols,
gases, vapors, and particulates (referred to here as “smoke and fumes”). The
smoke and fumes can include carbon monoxide and other chemicals depending
on the material being lasered and can Causes health hazards. The fan in the