EcubMaker TOYDIY - Page 8

------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------
--------
07
A
Welcome to choose EcubMaker
Safety Instructions
Laser Toolhead Module can blow away some smoke and fumes but it might still
be a bit smelly.
● Do not forget to check your local rules for air quality regulations that may apply
to you.
Materials Safety
● It’s recommended to only Laser Toolhead the following materials:
Wood, leather, Special PLA.
● Do NOT use Laser Toolhead engrave the following materials:
Metal, transparent material, reective materials, etc.
Materials that do not fit properly may obstruct operation and result in
damage and increase risk of re.
● The size of the material must be smaller than 180 x180 mm (7.0” x 7.0”).
● Do not place rolled-up material in the TOYDIY. It may be too tall, or unroll
during laser engraving, obstructing operation.