EcubMaker TOYDIY - CNC Toolhead Safety

------------------------------------------------------------------------------------------------------------------------------------------
--------
08
A
Welcome to choose EcubMaker
------------------------------------------------------------------------------------------------------------------------------------------
Safety Instructions
2.Safety Information-CNC Toolhead
Read it carefully
，
Improperly operating the TOYDIY can cause injury or other
serious consequences from the CNC Toolhead. Please read through this section
before you start CNC carving and ensure everyone else who uses it reads this
too.
Before You Start
● It is recommended that experienced users and users over 18 years old perform
the setup and use the CNC Toolhead.
● Wear the Safety Glasses before you set up the CNC Toolhead and throughout
the CNC carving process.
● The CNC Toolhead are sharp. Please handle them carefully and keep them
out of reach of children.
● Keep a safe distance from TOYDIY when it is carving.
● Do not use your TOYDIY while under the inuence of alcohol or drugs.
● Do not touch the CNC Toolhead while the TOYDIY is on. If you are cut by
accident, turn off TOYDIY immediately and seek help from doctors.
Electrical Safety
To reduce the risk of electric shock or re:
● Do not try to service, repair, or modify the TOYDIY.
● Never try to access the wiring of the TOYDIY.
● Do not open the power supply or any other sealed portion of the TOYDIY.
● If the TOYDIY is damaged, turn off TOYDIY, unplug the power adapter and
contact Support@zd3dp.com immediately.
● If there is any emergency or malfunction, turn off TOYDIY and unplug the
power adapter.
● Only use a properly grounded outlet.
Keep Watch During Operation
● Never leave the TOYDIY unattended while operating – always stay within
close aside and look at it frequently.
Materials Safety
● It’s recommended to only CNC Toolhead the following materials:
Wood, acrylic, PVC expansion sheet, plastic(ABS,PC,etc.)
● Do NOT CNC Carving the following materials. They may damage the TOYDIY
or cause injury.
Metal, etc.
Materials that do not fit properly may obstruct operation and result in
damage and cause injury.
● The size of the material must be smaller than 150 x150 x40 mm (5.9” x 5.9” x
1.5”).
● Do not place rolled-up material in the TOYDIY. It may be too tall, or unroll
during carving, obstructing operation.