EDAN iSe Series - Page 44

iSE Series Electrocardiograph Service Manual Electrocardiograph Disassembly
- 37 -
No.
Description
No.
Description
1
Button paste
2
Upper casing
3
Internal USB cable
4
Upper shield
5
Lower shield
6
Cross recessed pan head tapping screws
(M2.5×6)
7
Lower casing
8
Stopple
9
Light shield
10
Front end board
11
Light-conductive cover
12
Cross recessed pan head screw (M2.5×8)
13
Belt hole cap
/
Disassembly Steps:
1. Remove the four stopples and the four cross recessed pan head screws (M2.5×8) on the
pedestal, and then separate the upper casing and the lower casing and pull out the FPC cable
of the button paste carefully.
2. Take out the light shield, light-conductive cover, and front end board.
3. Remove the four cross recessed pan head tapping screws (M2.5×6) on the lower casing to
dismantle the pedestal.