EDAN SE-3 Series - Transmission Setup Configuration

SE-3&SE-300 Series Electrocardiograph User Manual Settings
- 52 -
Options
Corresponding USB Printers
HP
2010/1050/2000
HP Deskjet 2010
HP Deskjet 1050
HP Deskjet 2000
HP2015/2035/1525
HP Laserjet P2015
HP Laserjet P2035
HP Laserjet P1525
HP 1020
HP Laserjet 1020
HP 1505
HP Laserjet 1505
NOTE:
1. During the USB printing course, pressing the PRINT/STOP key
again cannot stop printing ECG reports.
2. For details of the ECG report printed by the USB printer, please
refer to section 6.3.2 "PDF Report".
3. USB printing is ineffective in the auto mode, OFF-AUTO, RHYT
mode and OFF- RHYT mode.
4. Make sure that paper is installed in the USB printer before
printing. Error may occur if no paper is loaded in the USB
Printer.
5. Make sure the type of USB printer connected is matched with
the type you choose in the Record Device. Error may occur if
the USB printer type is not matched.
USB Record Style
Choose from: 3×4, 3×4+1R, 3×4+3R, 6×2, 6×2+1R or 12×1, the
default value is 6×2
It defines the style of USB report.
Grid of Report
Choose from: On or Off, the default value is Off
When it is set to On, the grid will be printed while printing ECG reports
with the thermal recorder or USB printer.