Edge-Core EAP102 - Page 5

How to Use This Guide
– 5 –
July 2023 Revision
This is the 11th revision of this guide. It is valid for software release v12.4.1 and
includes the following changes:
 Added OpenRoaming, see “OpenRoaming” on page 57 and “Wireless
Networks — OpenRoaming” on page 76
 Modified broadcast rate, see “Physical Radio Settings” on page 64
 Access Control List enhancement, see “Wireless Networks — Security Settings”
on page 69
 Hostname enhancement, see “System Settings” on page 82
 Moved the language setting to the System page, see “System Settings” on
page 82
 Firmware upgrade enhancement, see “Upgrading Firmware” on page 87
 Account username enhancement, see “User Accounts” on page 88
May 2023 Revision
This is the 10th revision of this guide. It is valid for software release v12.4.0 and
includes the following changes:
 Added WAN port auto-detection to QR code Onboarding, see “QR Code
Onboarding” on page 26
 Added automatic mesh AP configuration, see “Mesh AP Configuration” on
page 29
 Removed Mark and Notrack from firewall rules, see “Firewall Rules” on
page 50
 Modified Minimum Signal Allowed, see “Physical Radio Settings” on page 64
 Added RF Isolation, see “Physical Radio Settings” on page 64
 Modified Dynamic VLAN, see “Wireless Networks — Network Settings” on
page 74
 Modified HotSpot 2.0 settings, see “Wireless Networks — Network Settings” on
page 74
 Added Log Level, see “System Settings” on page 82
 Added SNMPv3 User, see “SNMP” on page 94
 Modified Diagnostics and added Speed Test, see “Diagnostics” on page 97