Edge-Core EAP102 - Page 6

How to Use This Guide
– 6 –
January 2023 Revision
This is the ninth revision of this guide. It is valid for software release v12.3.0 and
includes the following changes:
 Updated QR code Onboarding, see “QR Code Onboarding” on page 26
 Updated wireless status, see “Wireless Status” on page 37
 Added support for dynamic PSK, see “Wireless Networks — Security Settings”
on page 69
 Updated Hotspot 2.0 settings, see “Wireless Networks — Network Settings” on
page 74
 Added CAPWAP Tunnel Interface to Ethernet Settings, see “Ethernet Settings”
on page 45
November 2022 Revision
This is the eighth revision of this guide. It is valid for software release v12.2.0 and
includes the following changes:
 Added Airtime Fairness, see “Physical Radio Settings” on page 64
 Modified the value range of BSS Coloring, see “Physical Radio Settings” on
page 64
 Modified wireless security default, see “Wireless Networks — Security Settings”
on page 69
 Added 802.11v, see “Wireless Networks — Security Settings” on page 69
 Added SNMP Trap, see “SNMP” on page 94
 Added BLE Scan, see “BLE” on page 96
November 2022 Revision
This is the seventh revision of this guide. It is valid for software release v12.1.0 and
includes the following changes:
 Updated SNMP read/write community settings, see “SNMP” on page 94
 Added BLE radio Tx Power, see “BLE” on page 96
 Added Interference Detection, see “Physical Radio Settings” on page 64
 Added zero-touch provisioning information, see “Zero-Touch Provisioning” on
page 19