How to Use This Guide
– 7 –
Modified the default value for Minimum Signal Allowed, see “Physical Radio
Settings” on page 64
Added 160MHz channel bandwidth option, see “Physical Radio Settings” on
page 64
Removed uCentral cloud option from the Setup Wizard.
July 2022 Revision
This is the sixth revision of this guide. It is valid for software release v12.0.0 and
includes the following changes:
Updated Setup Wizard for uCentral cloud, see “AP Setup Wizard” on page 21
Added Proxy ARP, see “Wireless Networks — Network Settings” on page 74
Added Multicast-to-Unicast Conversion, see “Wireless Networks — General
Settings” on page 68
Added Bandsteering, see “Physical Radio Settings” on page 64
Added WPA3 Enterprise 192-bit and OWE security, see “Wireless Networks —
Security Settings” on page 69
Added multiple PSK keys, see “Wireless Networks — Security Settings” on
page 69
Added Short Guard Interval (SGI), see “Wireless Networks — Advanced Radio
Settings” on page 78
Added Multicast/Broadcast Rate, see “Physical Radio Settings” on page 64
Added UPnP, see “LAN Settings” on page 48
Added DHCP Snooping, see “DHCP Snooping” on page 60
Added ARP Inspection, see “ARP Inspection” on page 61
Added DHCP Relay, see “DHCP Relay” on page 62
Added IPv6 for Internet access, see “IPv6 Settings” on page 45
Added Hotspot 2.0, see “Wireless Networks — Network Settings” on page 74
Added Device Discovery Tool, see “Device Discovery” on page 98
Added Discovery Agent settings, see “Edgecore Networks Discovery Tool” on
page 90
Added Reset button and LED enable, see “System Settings” on page 82
To Next Page
Loading...
