How to Use This Guide
– 8 –
Added PoE Out setting, see “Ethernet Settings” on page 45
Added caution on firmware upgrades in uCentral mode, see “Upgrading
Firmware” on page 87
April 2022 Revision
This is the fifth revision of this guide. It is valid for software release v11.6.0 and
includes the following changes:
Added Client mode, see “Physical Radio Settings” on page 64
Added Site Survey, see “Wireless Networks — General Settings” on page 68
Added Custom LAN, see “LAN Settings” on page 48
Added WME configuration, see “Physical Radio Settings” on page 64
Added BSS Coloring, see “Physical Radio Settings” on page 64
Added OFDMA, see “Physical Radio Settings” on page 64
Added Target Wake Time, see “Physical Radio Settings” on page 64
Added HTTPS captive portal, see “Captive Portal Settings” on page 55
Added HTTPS certificate upload, see “Upload Certificate” on page 87
December 2021 Revision
This is the fourth revision of this guide. It is valid for software release v11.4.0 and
includes the following changes:
Updated QR code onboarding, see “QR Code Onboarding” on page 26
Added mesh traffic graph to the dashboard, see “Traffic Graphs” on page 39
Added MSP mode, see “System Settings” on page 82
November 2021 Revision
This is the third revision of this guide. It is valid for software release v11.3.1 and
includes the following changes:
Updated the Setup Wizard, see “AP Setup Wizard” on page 21
Updated the Dashboard, see “Status Information” on page 32
Added Smart Isolation, see “LAN Settings” on page 48
Added Hotspot Settings, see “Hotspot Settings” on page 52
To Next Page
Loading...
