6. OPERATIONS AND ILLUSTRATIONS V-65E-A
6-17
Parameter description︰If the pusher cannot push the new bar material to
chuck facing position because it is blocked or
other reasons that the pusher will have inching
movement. But if it exceeds setting frequency
that bar feeder will Alarm.
Setting method︰ Input the required frequency.
Next page
Home page
1.2M Generally value：
Setting range ：
0~50
1.5M Generally value：
Setting value ：
Parameter description︰Set the starting time (ON) of bar pusher inching
moves so that the chuck of lathe will move at the
same time during bar feeder changes new bars.
Setting method︰ Input required time.
Previous page
Next page
Home page
1.2M Generally value：
Setting range ：
0~10
1.5M Generally value：
Setting value ：
Parameter description︰Set the ending time (OFF) of bar pusher inching
moves so that the chuck of lathe will stop moving
at the same time during bar feeder changes new
bars.
Setting method︰ Input required time.
Previous page
Home page
1.2M Generally value：
Setting range ：
0~10
1.5M Generally value：
Setting value ：
To Next Page
Loading...
