EDGE30 / EDGE2440 / EDGE40 / EDGE2460 / EDGE60 / EDGE3860
Installation and Operating Manual
Original Instruction Manual 38 Rev 2.1 July 12, 2016
– Reinstall the conveyor belt assembly.
– Reinstall the conveyor drive chain and drive chain cover.
Annual Maintenance (Service Technician)
Clean the Ignitor Electrodes (Spark Rod, Flame Rod, and Ground Rod).
Clean the Power Burner Blower fan blades.
Clean the control canister cooling fan blades.
Vacuum the control canister and remove debris.
IMPORTANT
Ensure that each finger assembly is reinstalled into the same location they were
removed from to avoid altering the baking characteristics of your oven.
WARNING
Any maintenance or service performed inside of the control can assembly or other
than listed in this manual should be performed by an authorized service company
to avoid oven damage.
WARNING
Following any maintenance, service work, or adjustments to the oven:
Ensure that the ventilation system is working properly.
Test for gas supply leaks.
Visually inspect the oven to make sure it has been reassembled correctly.
To Next Page
Loading...
