10
Notice: Use caution when inserting connector bodies. If the connector does
not slide smoothly, remove the connector, inspect the pins, and retry
installation.
Final Inspection
4. Recheck all connections for a properly secure installation. Using the
supplied wire ties, secure the wiring harness to prevent possible damage.
5
. Start the engine. The engine should start and run like a stock truck. If the
engine does not start or run properly, turn off the motor, remove the keys
from the ignition, then remove the juice module and inspect the pins inside
both connectors. Straighten pins or clear foreign material from the pins and
connector surfaces, then re-install the connectors. If failure conditions still
exist, contact your dealer or Edge Products, LLC. When trying to restart,
make sure that the key has been turned off for at least 10 seconds before
cranking the engine
.
To Next Page
Loading...
