14
Part Maintenance and Replacement
Replacing the Temperature Gauge
1) Remove the two screws from the temperature gauge seal with a Phillips screwdriver and remove
the seal.
2) Remove the two M8 ball nuts from the temperature gauge with an M8 hex socket wrench. Hold
the temperature gauge to prevent it from slipping o the surface, then remove the temperature
gauge and the cover ring.
3) Install the new temperature gauge and cover ring and replace the M8 ball nut on the top cover.
4) Replace the seal and tighten the two screws securely.
Tools Needed:
• Phillips Screwdriver • M8 Hex Socket Wrench
To Next Page
Loading...
