EdgeStar GRL270IBNG - Replacing the Gas Burner Valves

22
Replacing the Gas Burner Valves
3) Pull the gas manifold assembly slightly forward to expose the gas burner valves.
4) Remove the snap screw from the old valve and replace with a new valve. Replace the snap screw.
NOTE: All the valves need to be horizontally aligned.
Tools Needed:
• Phillips Screwdriver
1) Remove the drip tray.
2) Unscrew the Phillips screws on the left and right sides of the control panel as well as the screw
that a󰀩xes the gas manifold on the right side of the rebox.
5) Follow the above steps in reverse order to replace the necessary components.