24
Replacing the Rear Infrared Burner (Rotisserie Burner)
1) Close the hood to expose the louver cover at the rear of the grill.
2) Remove the four screws and the cover.
3) Use a #22 open-end wrench to unscrew the bellows nut and separate the stainless steel exiline
from the rear infrared burner connection.
4) Open the hood and unscrew the two screws of the infrared igniter cover.
5) Move the igniter assembly to the right to uncover the screw on the infrared bezel. Unscrew the left
and right side screws holding the bezel and remove the infrared burner.
6) Replace the infrared burner and follow the above steps to reinstall the necessary parts.
Tools Needed:
• Phillips Screwdriver • #22 open-end wrench
To Next Page
Loading...
