EdgeStar GRL270IBNG - Replacing the Rear Infrared Burner Igniter

26
1) Open the hood and unscrew the two screws of the infrared igniter cover.
2) Remove the large screw that xes the igniter and remove it.
Tools Needed:
• Phillips Screwdriver
Replacing the Rear Infrared Burner Igniter
3) Remove the drip tray.
4) Unscrew the Phillips screws on the left and right sides of the control panel as well as the screw
that a󰀩xes the gas manifold on the right side of the rebox.
5) Pull the gas manifold assembly slightly forward to expose the gas burner valves.