EdgeStar GRL270IBNG - Replacing the LED Knob Lights and Wires

19
Replacing the LED Knob Lights and Wires
1) Follow the steps on the previous page to remove the control panel.
2) After removing the control panel, remove the three large at screws on the insulation panel.
3) Remove the insulation panel and unplug the connection terminals of the LED lamps that you wish
to replace.
4) Unscrew the knurled nut that holds the LED light. Remove the light, and replace it. If you need
to replace the wires, remove all connecting terminals, disconnect the cable at the connector, and
replace them.
5) Replace the insulation panel and control panel.
Tools Needed:
• Phillips Screwdriver