EdgeStar GRL270IBNG - Replacing the Orifice

21
Replacing the Orice
1) Remove the drip tray.
2) Unscrew the Phillips screws on the left and right sides of the control panel as well as the screw
that a󰀩xes the gas manifold on the right side of the rebox.
Tools Needed:
• No. 6 open-end wrench • Phillips Screwdriver
3) Pull the entire gas manifold assembly forward slightly to expose the orices.
4) Use a No. 6 open-end wrench to unscrew the orice and replace it with a new one.
5) Follow the steps above in reverse to replace the necessary components.