17
Replacing the Internal Light
1) Remove the connection terminal that connects the internal light to the main electric wire. Attach a
long string to the connector.
2) Open the light cover by removing the phillips head screw.
2) Pull the light straight down while feeding the light cable (with string attached) through the unit.
Untie the string from the old light cable, tie string to new light cable, and pull string and cable back
into the unit from the other end.
3) Insert the new internal lamp in the same position, noting that the long foot is on the left.
4) Reattach the light cover and tighten the screw securely.
5) Reconnect to the main electric wire.
Tools Needed:
• Phillips Screwdriver • Long String
To Next Page
Loading...
