Edwards ELD500 Series

D135-10-880C - Operation
Page 62
Vacuum settings
ELD500 WET
Main menu > Settings > Vacuum settings
This menu allows to observe and to change the settings belonging to the vacuum system.
ELD500 DRY
The menu for the ELD500 DRY version allows the following vacuum settings which varies to
the ELD500:
6 Miscellaneous Settings like date or time (see Miscellaneous (language,
calibration request, service interval...)).
7 Parameter save /
load
Store and load sets of parameters (see Parameter save/
load).
8 Monitoring
functions
Choose functions of protection of the ELD500 in this mode
(see Monitoring functions).
Softkey 3: Vent delay
Definition of delay time until the ELD500 is vented
Softkey 4: Vacuum ranges
Selection of the vacuum working modes
Softkey 5: Partial flow setup/Forepump setup
Selection of partial flow mode and fore-pump type
Softkey 6: Sniffer factor
Setting for the sniffer factor
Softkey 7: Machine factor
Setting for the machine factor
Softkey 8: Leak rate internal test leak
Setting for the internal test leak
Softkey 3: Vent delay
Definition of delay time until the ELD500 is vented
Softkey 4: Vacuum ranges
Selection of the vacuum working modes
Key No. Name Description