© Edwards Limited 2007. All rights reserved. Page 37
Edwards and the Edwards logo are trademarks of Edwards Limited.
End User Controller (EUC) and Pump Display Terminal (PDT) menus
A419-00-880 Issue F
4 End User Controller (EUC) and Pump
Display Terminal (PDT) menus
4.1 Introduction
The display and the control buttons used on both the EUC and the PDT are shown in Figure 7.
The menu structure is shown in Table 15. Note that if a particular system component or accessory is not fitted, the
corresponding menu option is shown as ‘NP’ (not present).
Menus used and the display messages shown on the EUC and PDT are described in the menu diagrams in Figure 19 to
28. The following symbols and conventions are used in the menu diagrams:
These are flow lines. Arrows on the lines show the direction of flow through a menu.
This symbol is used to connect different menus and shows the starting point (or continuation point) of a menu.
This symbol is used for the ENTER and CANCEL buttons and the four menu buttons: Normal, Status, Control and Setup.
This symbol is used for the up (▲) and down (▼) buttons and for the on ( ) and off ( ) buttons.
This symbol is used for the two-line display on the PDT.
This symbol is a submenu box; a submenu is a series of menu steps which are used in a number of different menus or
used in different parts of one menu. Completion of the menu returns to the previous menu.
This symbol shows additional text which is not part of the menu, but which further describes the operation of the
menu.
To Next Page
Loading...