© Edwards Limited 2007. All rights reserved. Page 39
Edwards and the Edwards logo are trademarks of Edwards Limited.
End User Controller (EUC) and Pump Display Terminal (PDT) menus
A419-00-880 Issue F
4.5 Wrap-around
When you use the up and down buttons to change a digit or character on the display, the digit or character will 'wrap-
around' between its minimum and maximum values. For example, when you enter a password digit, if the digit is '0'
and you press the down button, the digit will change to '9'; if the digit is '9' and you press the up button, the digit will
change to '0'.
4.6 Timeout
After you have entered a menu (other than the Normal menu), if you do not press a button for five minutes, the EUC
or PDT will automatically exit the current menu and enter the Normal menu. This facility (known as timeout) is
available so that if the setup menu is entered and then EPX system is accidentally left unattended, the menu is exited
to prevent unauthorized use of the menu options.
4.7 Menu structure
The display and the control buttons are shown in Figure 7.
The menu structure is shown in Table 15. Note that if a particular system component or accessory is not fitted, the
corresponding menu option is shown as 'NP' (not present).
Table 15 - EUC and PDT menu structure
Menu Figure
PDT menu logic 19
Switch on 20
Switch off 21
Normal (default) Menu 22
Status Menu 23
Control Menu 24
Setup Menu 25
Software Version 26
Select Units Menu 27
Select Line Menu 28
Service Menu Service Personnel only
Serial Number Service Personnel only
Time/Date Service Personnel only
To Next Page
Loading...