Edwards iXM200

Display aributes menu
1. This is a sub menu of the SETUP menu. Pr
ess up/down keys to scroll. Press ENTER
to open a sub menu.
2. Press CANCEL to return to the SETUP menu.
Table 29 Display aributes menu
Normal display (Selects the parameters displayed in Normal)
Units…
SELECT LINE (Normal display selecon menu)
1. Press up/down keys to scroll. Press ENTER to open a sub menu.
2. Press CANCEL to return to the Display aributes menu.
3. Refer to Table: SELECT LINE (Normal display selecon menu). In each opon the
SELECT PARAMETER menu is opened, press up/down keys to scroll through the
parameters. Press ENTER to select the parameter for display.
4. Press CANCEL to return to the SELECT LINE menu.
Table 30
SELECT LINE (Normal display selecon menu)
Top Page 1…
Boom Page 1…
T
op Page 2…
Boom Page 2…
UNITS (Units to display menu)
1. Press up/down keys to scroll. Press ENTER to open a sub menu.
2. Press CANCEL to return to the Display aributes menu.
3. Refer to Table: UNITS (Units to display). Press up/down keys to scroll through the
units available in each opon. Press ENTER to select the display units.
4. Press CANCEL to return to the UNITS menu.
Note:
The conguraon
opons for the PDT are stored in the PDT itself and are not
associated with the pump that the PDT is connected to. This means a user can
transfer a PDT between pumps and keep the same sengs. It also means that
dierent units can be displayed on two PDTs connected to the same pump.
Table 31 UNITS (Units to display)
Pressure... (PSI/kPa/ mbar/Torr)
Temperature... (Cengrade/Fahrenheit/ Kelvin)
Speed... (RPM/Hz)
Acv
e Gauge... (mbar/Torr/kPA)
10/2020 - ©Edwards Limited
Page 58M56635880_D
M56635880_D - Commission