Edwards Microvac 149-HS

© Edwards Limited 2011. All rights reserved. Page 31
Edwards and the Edwards logo are trademarks of Edwards Limited.
Maintenance
S149-01-880 Issue F
5.10 Fitment or replacement of the motor (412J models only)
The following motors can be fitted to 412J Pump Modules with the Universal Motor Mounting Platform attached.
Note: This is valid for pump modules with a serial number above 076227658.
Figure 14 - Collar bolt positions and motor frame sizes
WARNING
A new safety review may be required following fitment of any motor. Particular attention should
be made to the effectiveness of the drive guard to restrict finger access to the motor shaft and all
other rotating parts.
Table 7 - Motors the can be fitted to 412J pump models
Motor Frame
Size
Line
frequency
Motor
Pulley
Collar Bolt
Position
Platform
Nominal
Inclination
Drive Belt Size
Standard Pump
Article Codes
IEC D160M 50 Hz 6 inch A -0.5 º B105 (L=2720) 900412014501
60 Hz 5 inch B -4.1 º B105 (L=2720)
NEMA 215T 50 Hz 6 inch C -7.7 º B105 (L=2720)
60 Hz 5 inch C -3.0 º B105 (L=2720) 900-412-014
NEMA 254T 60 Hz 5 inch B -4.0 º B105 (L=2720)