17
4.2 System Parameter Setup
At RESET condition, press “SYSTEM” key to enter SYSTEM parameter setup and SYSTEM indicator
will light up. The indication of SYSTEM setup menu will be shown at the Voltage display and the
setup parameter for each SYSTEM setup will be shown at Current display. By pressing the “︿” or
“﹀” key from the Voltage display, it then allows to scroll the SYSTEM parameter setup menu;
Auto run, PLC Remote, GPIb Addr, Auto Adj, P–UP, t Unit, LooP rAtE, FrEq HI, FrEq LO, Volt HI, and
Volt LO settings. Pressing the “︿” or “﹀” key from Current display allows varying the parameter
value of the system setup. Press SYSTEM key again to return to standby condition after the system
parameter setup has completed.
To Next Page
Loading...
