EEC 6500 Series - 4.3 Program Parameter Setting

21
4.3 Program Parameter Setting
At RESET condition, press “PROGRAM” key to enter PROGRAM parameter setup whereby the
“PROGRAM LED” indicator is lit. In the meanwhile, the indication of PROGRAM setup menu will be
shown at the Voltage display and the setup parameter for each PROGRAM setup will be shown at
Current display. By pressing the “︿” or “﹀” key from the Voltage display, it then allows to scroll
the PROGRAM parameter setup menu; Prog, Loop CyCL, StEP, Volt, FrEq, tESt t, dLAy t, A-HI, A-LO,
P-HI, P-LO, PF-H, PF-L, Conn StEP. Pressing the “︿” or “﹀” key from Current display allows
varying the parameter value of the PROGRAM setup. Press PROGRAM key again to return to
standby condition after the PROGRAM parameter setup has completed.