EFD 2000XL - Saving a Time in a MEMORY Cell; To Recall and Use a Time in MEMORY

Saving a time in a MEMORY cell
1. Determine the cell in which a new time value is to be stored, e.g.,
CEL1 , CEL2 ... (Refer to "Viewing MEMORY cells" on page 20).
2. Press RUN/SETUP to place the dispenser in SETUP mode (SETUP
indicator light on).
Note: Once cell value s are cleared, they canot be recalled.
3. Press STEADY/TEACH to clear cell contents.
4. Enter the desired time setting by using the TIME SET button or the
TEACH function and foot pedal (refer to page 12).
5. Press RUN/SETUP to place the dispenser in RUN mode (RUN
indicator light on) and save the setting in cell memory.
The dispenser is now ready to use the preset value you just stored.
To recall and use a time in MEMORY
In the RUN mode, press CELL SELECT (up) (down) to step through the
cells until you locate the desired cell. The dispenser is now ready to
use the time stored in the selected cell.