Basic settings
The changing of these parameters is not possible for types 1000RM / 1500RM.
The following parameters can be changed via the basic settings:
– output voltage (220 V, 230 V, 240 V AC).
– output frequency (50 Hz, 60 Hz) in support operation; the
input frequency must be adjusted.
Scroll with the key "Menu down" in a switched-off state to the display
INVERTER MODE The cursor can now be set to LO or HI with the key "Menu
selection." The voltage threshold for the inverter mode can be changed via the
keys "Menu down" and "Menu up."
Scroll with the key "Menu down" in a switched-off state to the display
VOLT/FREQ SET. The cursor can now be set to Vac (output voltage) or Hz
(output frequency) with the key "Menu selection." The output voltage or the
output frequency, in the switched-off state, can be changed via the keys "Menu
down" and "Menu up."
The output frequency can have the following settings:
– 50 Hz -> Output frequency 50 Hz
– 60 Hz -> Output frequency 60 Hz
Confirm the entry with the key "Menu selection."
To Next Page
Loading...
