How-To: Using the IQ-501 with the Fiery server
21
15. The Calibration measurement results are
shown.
Ensure that the D Max values displayed are
within the expected tolerance for the engine and
media selected. Reprint or take appropriate
service steps if not.
16. Click Next to continue the calibration of the
second (and subsequent) server(s).
17. The Fiery Measure job properties window opens
for the second server.
18. Select the Media tab.
19. Select the media attributes for the media you
wish to use.
20. Click OK to print and measure the calibration
chart for the second server.
To Next Page
Loading...
