Cummins 2010-2018 Quick Start
support@efilive.com - 17 - www.efilive.com
8. Click the OK button to initiate the flash operation.
9. When the flash process is complete the Reset Controller notification will be
shown. When prompted perform the following actions:
a. Turn the vehicle ignition Off.
b. Click on the Start button to begin the countdown timer.
c. DO NOT turn the vehicle ignition on until the countdown timer
expires. This time is critical to allow the ECM to perform internal functions
after a read/flash operation.
AutoCal
Follow these steps to license and flash the selected controller.
1. Install AutoCal configuration files provided by your Tuner if not already setup.
2. Copy selected tune file(s) from your PC to FlashScan V2 if not already copied.
3. Connect your AutoCal device to your vehicle.
4. Turn the vehicle ignition to the On or Accessory position (vehicle must not be
cranked/running when flashing).
5. Navigate using the arrow keys to the Full 1-5 options for full flash.
6. Select the correct tune file from those listed and select OK.
7. If the controller has not been licensed by the selected AutoCal device, you will be
presented with the message License controller? Select OK to license the
controller.
8. Click the OK button to initiate the flash operation.
9. When the flash process is complete the Reset Controller notification will be
shown. When prompted perform the following actions:
a. Turn the vehicle ignition Off.
b. Click on the Start button to begin the countdown timer.
c. DO NOT turn the vehicle ignition on until the countdown timer
expires. This time is critical to allow the ECM to perform internal functions
after a read/flash operation.
To Next Page
Loading...