Cummins 2010-2018 Quick Start
support@efilive.com - 10 - www.efilive.com
4. If the [Select PIDs] option is not selected first, the following will be
displayed:
--------
VIN
3D7KS26>
--------
SN:
Sel PIDs
--------
OS:
Sel PIDs
--------
Cal:
Sel PIDs
--------
Record All Diagnostics
FlashScan V2 and AutoCal have the ability to create a text file that can be viewed
using Windows notepad.
FlashScan V2
1. With FlashScan V2 connected to your vehicle, select [F1: Scan Tool] ->
[F1: Select PIDs] and select controller you wish to display.
2. Return to the main menu, then select [F3: Diagnostics] -> [F4: Record All
Diags]. FlashScan will display the file name that is saved onto the device.
3. If a controller is not selected in the Select PIDs menu, users will be
presented with the message: "Freeze frame data will not be recorded until
a PID selection is made." Select OK for FlashScan to create the file without
any freeze frame data.
AutoCal
1. For AutoCal, the user must boot into the advanced menu (i.e. hold down
[Next] button while powering up), then navigate to [Trouble Codes] ->
[Record Diags]. AutoCal will display the file name that is saved to the
device.
2. If a controller is not selected in the Select PID's menu, users will be
presented with the message: "FF Data not rec." Select OK for AutoCal to
create the file without any freeze frame data.
Once the file is saved, users should connect their FlashScan or AutoCal
device to their PC, Open EFILive Explorer and navigate to the scan directory.
The relevant file can then be transferred to PC and then opened or emailed to
their tuner.
Match Calibration Requirements
1. Using the Calibration ID identified in the above steps, search the Cummins
Flash Availability Document for that entry.
2. Copy the Calibration ID without the 2 letter suffix from the New Part Number(s)
column.
3. To find a matching tune file, open the chosen CMD.ctz or CME.ctz file in to
EFILive V8 Scan and Tune and match the Calibration ID displayed under the
[F3: Tune] -> [F3: Calibration] tab against the Calibration ID chosen from the
Cummins Flash Availability document.
To Next Page
Loading...