Efka Variocontrol V820 - Operating Elements of the V820 Control Panel

EFKA DA82GA3312
55
10 Operating Elements of the V820 Control Panel
variocontrol 820
P E
KL2186
41 2 3
B
R
85 6 7 9 0
A
+
-
F
1
The V820 control panel is supplied with slide-in strip no. 1 above the keys.
Function Key Assignment
Key P = Call or exit of programming mode
Key E = Enter key for modifications in the programming mode
Key + = Increase of the value indicated in the programming mode
Key - = Decrease of the value indicated in the programming mode
Key 1 = Start backtack SINGLE / DOUBLE / OFF
Key 2 = Stitch counting seam FORWARD / BACKWARD / OFF
Key 3 = Light barrier function COVERED-UNCOVERED / UNCOVERED-COVERED / OFF
Key 4 = End backtack SINGLE / DOUBLE / OFF
Key 5 = THREAD TRIMMER / THREAD TRIMMER + THREAD WIPER / OFF
Key 6 = Automatic sewing foot lift after thread trimming ON / OFF
Automatic sewing foot lift at stop in the seam ON / OFF
Key 7 = Basic position needle down (POSITION 1) / needle up (POSITION 2)
Key 8 = Thread monitor ON / OFF (>1 sec) or reset (<1 sec)
Key 9 = Function key, programmable
Key 0 = Teach-in / execution of 40 possible seam sections
Key A = Key for backtack suppression/recall
(Different input functions can be assigned to key A using parameter 293)
Key B = Key for needle up or shift key in the programming mode
(Different input functions can be assigned to key B using parameter 294)
Special Key Assignment for HIT
After having pressed key 1, 2, 3, 4 or 9, the following can be varied using key +/-:
Key 1= Number of stitches of the selected start backtack
Key 2= Number of stitches of the seam with stitch counting
Key 3= Number of light barrier compensating stitches
Key 4= Number of stitches of the selected end backtack
Key 9 = Number of stitches or On/Off of the programmed function