EFKA DA82GA3312
6
1 Range of Applications
The drive is suitable for lockstitch, machines:
Brand Series
DÜRKOPP ADLER N291, 069, 204, 205, 221, 266, 267, 268, 269,
366, 271, 381, 382, 467, 767, 768, 4180, 4280, 8967
1.1 Use in Accordance with Regulations
The drive is not an independently operating machine, but is designed to be incorporated into other machinery. It must not
be put into service until the machinery into which it is to be incorporated has been declared in conformity with the
provisions of the EC Directive (Appendix II, paragraph B of the Directive 89/392/EEC and supplement 91/368/EEC).
The drive has been developed and manufactured in accordance with the relevant EC standards:
EN 60204-3-1:1990 Electrical equipment of industrial machines:
Particular requirements for industrial sewing machines, sewing units and sewing systems.
Operate the drive only
on thread processing machines
in dry areas
2 Scope of Supply
1 Direct current motor DC1600
1 Electronic control vario dc DA82GA3312
- Power pack N153 (optional N155)
- Actuator EB301 (optional EB302, softer spring)
1 Control panel V810 (optional V820)
1 Position transmitter P6-1
1 Power switch NS108 (optional NS108D)
1 Set of standard accessories B131 1 Set of accessories Z57
consisting of: belt guard, complete consisting of: extension cable for EB3..
set of hardware
motor mounting foot
bracket 1 and 2, short
documentation
Note
If there is no metallical contact between drive (motor) and machine head, the potential equalization cord supplied
with the unit is to be wired from the machine head to the terminal provided on the control box!
CAUTION
When selecting the installation site and the layout of the connecting cable, the safety
instructions must be followed with no exceptions.
Particular attention should be paid to maintaining the proper distance from moving
parts!
To Next Page
Loading...
