Efka Variocontrol V820 - Maximum Number of Seams Exceeded; Execution (Pattern) Mode; Further Settings for TEACH in

EFKA DA82GA3312
19
3.7.6 Maximum Number of Seams Exceeded
If by inputting a program the total number of 40 seams is exceeded, the teach-in mode cannot be completed by pressing the
P key. A new start of sewing is impaired. The display shows a warning (dEL). By pressing the P key again the pattern
displayed will be deleted. Exit the teach-in mode now if the total number of 40 seams is not exceeded. Otherwise there will
be a new warning.
Display:
X: Last input or selected pattern number (1...8)
YY: Number of programmed seams of the selected 
pattern (0...40)
NN: Total number of input seams if more than 40
The user must now decide which pattern should be deleted !
Selection of the pattern to be deleted 
X: Pattern number
YY: Number of seams of this pattern
NN: Total number of input seams if more than 40
Deletion of the pattern 
X: Pattern number of the deleted pattern
YY: 00 = no more seam is programmed
NN: Total number of input seams if more than 40
Exit the teach-in mode if the number of seams equals or falls below 40, and the last input seam will be displayed.
3.7.7 Execution (Pattern) Mode
↓
↓↓
↓
Enable mode by pressing key 0
1
 (arrow above key 0 lights up). 
Seam number 01 is displayed.
Select pattern 1...8.
2
If you do not wish to start with seam 1,
3
 press the E key several times until the 
desired seam number is displayed !
Start the pattern by pressing the pedal !
Complete the execution (pattern) mode;
4
Disable mode by pressing key 0!
3.7.8 Further Settings for TEACH IN
Functions Parameter
Seam suppression if 0 stitches are set (Std) 275
Parameter 275 = 0 Seam suppression disabled: i. e. if the light barrier is Off and stitch counting is set at 0 stitches, a
free seam will be performed.
dEL X YY NN
0
dEL X YY NN
P
dEL X YY NN
0 X 01 ZZZ
+
- X 01 ZZZ
E
X 05 ZZZ
0