3) The recommended scanning method is to start with a molar, since it has
greater details for easier identification. Change the scanning angle to less than
60 degrees during scanning to allow the surfaces to overlap, if the overlap is
too small, the alignment may be lost.
4) The recommended scanning protocol consisting of 3 sweeps: occlusal,
lingual and buccal to ensure good data coverage of all surfaces. It is
recommended to start the first sweep from the bite surface. If there is a
preparation, start with preparation so that the gingival area can be scanned
before gum collapses; if there is no preparation (for example, in orthodontic
cases), you should start with the first molar. The second sweep can scan both
the lingual and buccal sides, and the third scan covers the opposite side of
the second sweep.
6.1.4 Data editing
After pressing the button on the scanner to stop scanning, the software
Page 26 / 51
To Next Page
Loading...