EINHELL GC-SP 2275 User Manual

GB
- 18 -
11. Troubleshooting guide
Faults Cause Remedy
The equipment
does not start
- Power supply not connected
- Floating switch does trigger
- Check power supply
- Raise position of fl oating switch
The equipment
does not pump
- Intake sieve clogged
- Discharge hose kinked
- Clean intake sieve with water jet
- Unkink the hose
The equipment
does not cut out
- Floating switch cannot sink - Place equipment correctly on shaft
bottom
Insuffi cient pumping
rate
- Intake sieve clogged
- Performance reduced due to heavi-
ly contaminated and abrasive water
impurities
- Clean intake sieve
- Clean equipment and replace wear
parts
The equipment swit-
ches off after briefl y
running
- Motor circuit-breaker switches the
equipment off due to excessive wa-
ter contamination
- Water temperature too high; motor
circuit-breaker switches the equip-
ment off
- Unplug power plug and clean
equipment and shaft
- Ensure that maximum permissible
water temperature (35 °C) is not
exceeded
Anl_GC_SP_2275_SPK13.indb 18Anl_GC_SP_2275_SPK13.indb 18 30.01.2023 10:14:4730.01.2023 10:14:47

EINHELL GC-SP 2275 Specifications

General

Type	-
Proper use	Pond
Product color	Black, Red
Housing material	Plastic
Suitable for indoor use	No
Suitable for outdoor use	Yes
Flow rate	7500 l/h
Maximum delivery height	6 m
Maximum operating pressure	- bar
Maximum input water temperature	35 °C
Package depth	169 mm
Package width	222 mm
Package height	278 mm
Package weight	3700 g
Quantity per pack	1 pc(s)
AC input voltage	230 V
AC input frequency	50 Hz
Cable length	10 m
Connecting thread type	G1 1/2

Weight and Dimensions

Weight	2300 g