EINHELL TC-BD 630 User Manual

GB
- 14 -
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment. En-
sure that no water can seep into the device.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Subject to technical changes
Anl_TC_BD_630_EX_PH_SPK7.indb 14Anl_TC_BD_630_EX_PH_SPK7.indb 14 28.10.2020 13:30:5328.10.2020 13:30:53

EINHELL TC-BD 630 Specifications

General

Chuck type	Key
Chuck mount	B16
Product type	Bench drill press
Product color	Black, Red
Throat depth	126 mm
Angle drilling	-
Variable speed	Yes
Number of speeds	12
Drilling depth (max)	60 mm
Rotational speed (max)	2450 RPM
Rotational speed (min)	250 RPM
Drill bit diameter (min)	1.5 mm
Drilling diameter in steel (max)	16 mm
AC input voltage	230 V
AC input frequency	50 Hz
Drill table tilting	-45 - 45 °

Weight and Dimensions

Depth	765 mm
Width	430 mm
Height	195 mm
Weight	32550 g