GB
- 9 -
Protection against fi re and explosion
There are spark producing components inside
the device. Do not use the device in the vicinity of
combustible liquids or gases. Otherwise there is a
risk of fi re or explosion.
Handle the device with care
Do not use the cable to pull the plug out of the
socket. Protect the cable from heat, oil and sharp
edges. Keep your tools sharp and clean so that
you can work effi ciently and safely. Follow the
maintenance regulations and the instructions for
changing tools.
Wear suitable work clothes and personal pro-
tection equipment
Loose clothing is not suitable, as it can be caught
by moving parts, causing you to become ent-
angled. Wear a hair net if you have long hair. As
a general rule, jewelry should not be worn when
working with machine tools. Ensure that you wear
safety goggles. Not doing so could result in eye
injury.
Keep your work area neat and tidy
Disorder in the work area can easily lead to acci-
dents. Do not leave any tools, objects, or cable in
the direct vicinity of the work area, as this poses
a tripping hazard! Ensure that there is suffi cient
lighting.
Watch out for other persons
Watch out for other persons (especially children)
when using the device, and keep them away from
your work area. Do not let anyone touch the de-
vice or the power cable.
Store the tools in a safe location
Store unused devices in a dry, locked location
that is out of the reach of children.
Avoid overloading the device
Operate the device only within the specifi ed out-
put range. Do not use any low-powered machines
for heavy duty work. Do not use tools to perform
work for which they were not intended.
Maintain a steady foothold
Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and al-
ways keep your balance.
Pull out the mains plug
Pull out the mains plug when not using the tool,
prior to maintenance, and when changing the drill
bit.
Pull out the power plug.
Ensure that the mains connection is protected by
at least a 10 A-rated fuse.
Avoid unintentional start-up
Ensure that switch is turned off when plugging the
plug into the socket.
Keep an eye on your work
Always keep an eye on your machine and the
object you are working on. Never use the machine
when you are not concentrating or are distracted.
Never use the machine when you are under the
infl uence of alcohol or are taking medication.
Check the tool for damage
Before using the tool, safety devices and any
slightly damaged parts must be carefully checked
to ensure that they are in good working order. Vi-
sually examine the tool’s power cable on a regular
basis. All parts must be correctly assembled and
meet all the conditions required to ensure proper
operation. Unless otherwise specifi ed in the ope-
rating instructions, any damaged safety devices
and parts must be properly repaired or replaced
by a professionally recognized workshop. Never
use tools with defective On/Off switches.
Warning! Using any plug-in tools and accesso-
ries other than those specifi ed in these operating
instructions can lead to injury.
Now, please read and follow all steps and
procedures included in the operating instruc-
tions.
2. Layout and items supplied
2.1 Layout
1. Machine base
2. Pillar
3. Fastening screws
4. Drill table
5. Drill table clamp shaft
6. Machine head
7. V-belt cover
8. Motor
9. Grip knobs
Anl_TC_BD_630_EX_PH_SPK7.indb 9Anl_TC_BD_630_EX_PH_SPK7.indb 9 28.10.2020 13:30:5328.10.2020 13:30:53
To Next Page
Loading...
Need help?
General
Weight and Dimensions
