EINHELL TC-TS 2225 U User Manual

GB
- 76 -
•
Using the crank (10) set the saw blade (4) to the maximum cut-
ting depth.
•
Remove the table insert (6) by undoing the countersunk head
screw (17) (see 6.4).
•
Remove the splitter (5) together with the saw blade guard (2)
(see 6.5).
•
Undo the screw (15) with a wrench (38) on the screw (15) itself
and a second wrench (39) on the motor shaft to apply counter-
pressure.
•
Caution! Turn the screw (15) in the direction of rotation of the saw
blade.
•
Take off the outer flange and pull the old saw blade (4) off the in-
ner flange.
•
Clean the blade flange thoroughly before fitting the new blade.
•
Fit and fasten the new saw blade (4) in reverse order.
•
Important! Note the running direction. The cutting angle of the
teeth must point in running direction, i.e. forwards (see the arrow
on the blade guard).
•
Refit and set the splitter (5) and the saw blade guard (2) (see
6.5.)
•
Check to make sure that all safety devices are properly mounted
and in good working condition before you begin working with the
saw again.
•
Warning! Every time that you change the saw blade, check that
the saw blade guard (2) opens and closes again in accordance
with requirements. Also check that the saw blade (4) spins freely
in the saw blade guard (2).
•
Warning! Every time that you change the saw blade (4), check to
see that it spins freely in the table insert (6) in both perpendicular
and 45° angle settings.
•
Warning! You should replace the table insert (6) immediately
whenever it is worn or damaged (see 6.4).
•
Warning! The work to change and align the saw blade (4) must
be carried out correctly.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 76 24.03.2020 10:29:26

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm