Eizo FlexScan EV2411W

26
Chapter 3 Connecting Cables
●
To set input signal selection [Input Signal]
ThemonitorrecognizestheconnectorthroughwhichPCsignalsareinput.
When either PC is turned off or enters the power-saving mode, the monitor
automaticallydisplayssignalsofanotherPC.
Priority setting Function
Auto When either PC is turned off or enters the power-
saving mode, the monitor automatically displays
signals of another PC.
Manual The monitor detects only the PC’s signals currently
displaying automatically. Select an active input signal
with .
[Input signal setting]
(1) Choose <Others> from the Adjustment menu, and press
.
(2) Choose <Input Signal> from the <Others> menu, and press .
The<InputSignal>menuappears.
(3) Select “Auto” or “Manual” with or , and press .
Thesettingiscompleted.
3-2 Adjusting the DVI Input Level
[DVI Input Level]
This function allows you to adjust the DVI signal input level when using a DVI
longcable.
Adjustment range: Auto, Manual (1 to 8)
(1) Press toturnoffthemonitor.
(2) Press holding downtoturnonthemonitor.
The<DVIInputLevel>adjustmentmenuappears.
(3) Select “Auto” or “Manual” with or .
When selecting “Manual”, adjust the input level with or todisplaycorrectly.
(4) Press .
Theadjustmentiscompleted.
Attention
• Select "Manual" only if a noise
appears on the screen when using a
DVIlongcable.
Attention
• Select "Manual" only if a noise
appears on the screen when using a
DVIlongcable.
NOTE
• When “Auto” is selected for <Input
Signal>, the monitor’s power-saving
function works only when the two
PCsareinthepower-savingmode.