Eizo FLEXSCAN S2233W - Chapter 5 Reference; Attaching An Arm

34
Chapter 5 Reference
Chapter5 Reference
5-1 AttachinganArm
The stand can be removed and replaced with an arm (or another stand) to be
attached to the monitor. Use an arm or stand of EIZO option.
1
 LaytheLCDmonitoronasoftclothspreadoveronastable
surfacewiththepanelsurfacefacingdown.
2
 Removethestand.(Prepareascrewdriver.)
Unscrew the four screws securing the unit and the stand with the
screwdriver.
3
 Attachthemonitortothearmorstand.
Secure the monitor to the arm or stand using the screws specied in the
user’s manual of the arm or stand.
Attention
• When attaching an arm or stand,
follow the instructions of their user’s
manual.
• When using another manufacturer’s
arm or stand, conrm the following in
advance and select one conforming to
the VESA standard.
– Clearance between the screw holes:
100 mm × 100 mm
– Thickness of plate: 2.6 mm
– Strong enough to support weight of
the monitor unit (except the stand)
and attachments such as cables.
Use the screws as described below.
– EZ-UP stand
Free mount type:
The screws supplied with this
monitor (M4 × 12mm)
– FlexStand
Height adjustable stand:
The screws xing the stand to the
monitor
• When using an arm or stand, attach it
to meet the following tilt angles of the
monitor.
– Up 45 degrees, down 45 degrees
(horizontal display, and vertical
display rotated 90 degrees
clockwise)
• Connect the cables after attaching an
arm.
• If you need to remove the EZ-UP
stand, turn the panel on the monitor
to the left and right a little to appear
the four screws positioned under the
stand. Then unscrew the four screws.