English
5. ATTACHING A STAND
25
5. ATTACHING A STAND
The LCD monitor can be used with other stand by removing the tilt stand and attaching
the stand to the LCD monitor.
NOTE
• When attaching an arm or stand, follow the instructions of their user’s manual.
• When using another manufacturer’s arm or stand, confirm the following in advance
and select one conforming to the VESA standard.
- Clearance between the screw holes: 100 mm x 100 mm
- Thickness of plate: 2.6 mm
- Strong enough to support weight of the monitor unit (except the stand) and
attachments such as cables.
• Attach an arm or stand to meet the following tilt angles of the monitor.
- Up 45 degrees, down 0 degrees (Within operating range)
• Please connect cables after attaching a stand.
Setup Procedure
1. Lay the LCD monitor down. Do not scratch the panel.
2. Remove the tilt stand by loosening the 4 screws.
3. Attach a stand to the LCD monitor securely with the same screws.
4 Mounting Screws: M4 x 12 mm
stand
To Next Page
Loading...
Need help?
General