- 13 -
STEP 4
Tighten the fitting barbs in the clockwise direction until the gasket
underneath is compressed.
The installation of the CPU water block is now complete.
With EK-Velocity series water blocks, it is mandatory
to use the port closest to the center of the water block
as the INLET port. Mixing these ports up may result in
poor thermal performance of the water block.
STEP 4
Fitting Ring
Fitting Barb
Inlet port
Outlet port
LGA115x SOCKET MOTHERBOARDS
STEP 1
If already installed, you can choose to remove the motherboard from
your PC, then place it on an even surface with its front facing down.
STEP 2
Preparing the Backplate Rubber Gasket:
The enclosed rubber gasket is an essential part of the backplate and
mounting system – it must be used every time you install this water
block on the motherboard.
The rubber gasket has a partially cut inner part, which
needs to be removed before installation on the Intel® LGA-
115x motherboard. The rubber is held in four places and
can be peeled away by hand.
Outer part
(Removable)
Inner Core
STEP 2
To Next Page
Loading...
