ekwb EK-Quantum 240 - Connecting the Fans, Pump and Cpu D-Rgb Lights

- 32 -
CONNECTING THE FANS, PUMP AND CPU
DRGB LIGHTS
STEP 1
Connect the 3-pin D-RGB LED connector from the pump-reservoir
unit, water block, and fans to the D-RGB header on the motherboard.
The lights will work if the pin layout on the header is as follows: +5V,
Data, Empty, Ground.
Please ensure that the arrow indicated on the connector is
plugged into the +5V line, as indicated on your motherboard. If
you connect LEDs to the 12V RGB header, it will damage them.
You may use the enclosed 6-way D-RGB splitter cable to connect all
the D-RGB cables into one header on your motherboard.
D-RGB Header
RGB Header
STEP 1
D-RGB Connector
6-Way D-RGB Male
Splitter Headers
D-RGB
Connectors